Skip to content
Hire and site services

Coal transport by road in South Africa: trucks, payload and permits for coal, chrome, ore and sand

In short

Coal transport by road in South Africa mostly runs on 34 ton side tippers: seven-axle interlinks held to 56,000 kg gross. Their payload is about 35 tons, and the same trucks suit chrome and iron ore. The buyer carries duties too: a consignor must get the operator's written payload statement and may not contract an overloaded truck.

Part ofHaulage34 ton side tipper truck hire

Tell us about the loads

Headcore10 min read15 sources

Which truck carries coal, chrome, ore or sand?

The side-tipping interlink is the usual bulk truck. A 2015 trade article says it carries a bigger legal payload than two- and three-axle end-tipping semi-trailers, tips more stably and suits iron ore, chrome ore and coal. In the table, a performance-based (PBS) coal interlink in a CSIR trial carried the most, about 50 tons on average. A 40 cube twin-bin semi-trailer is rated lowest, at 30,540 kg. For the 34 ton work itself, see side tipper hire; short site hauls of sand or rubble on rigid trucks are tipper truck hire.[13][9][14]

Which truck carries coal, chrome, ore or sand?
CombinationGross combination massPayloadLengthSource of the figure
PBS tridem interlink on coal, approved routes only74,000 kgAbout 50 tons, trial average22 m, whole combinationCSIR trial data, 2017 to 2019
25 cube TA/TA side tipper interlink56,000 kg36,550 kg rated16.5 m, as publishedTrailer maker's figures, 2022
40 cube TA/TA side tipper interlink56,000 kg35,340 kg rated17.7 m, as publishedTrailer maker's figures, 2022
Conventional coal interlink (B-double), tandem axles on the trailers56,000 kgAbout 35 tons, trial average22 m, whole combinationCSIR trial data, 2017 to 2019
45 cube TA/TA side tipper interlink56,000 kg34,780 kg rated17.7 m, as publishedTrailer maker's figures, 2022
40 cube twin-bin TRA side tipper semi-trailer49,500 kg30,540 kg rated14.9 m, as publishedTrailer maker's figures, 2022

Sources:[14][9]

How many tons may a 34 ton side tipper legally carry?

Without a special permit, a loaded truck and trailers may weigh no more than 56,000 kg on a public road, which leaves the 34,780 to 36,550 kg payload one maker rates its interlinks at. Regulation 237 of the National Road Traffic Regulations caps the permissible maximum combination mass at 56,000 kg, and at 48,000 kg behind a haulage tractor with a single driving axle. PBS combinations run heavier only under special permit.[3][2][14][9]

Below that cap, each axle has its own limit. Regulation 240 allows 7,700 kg on a two-wheeled steering axle and 18,000 kg on a two-axle unit with four wheels per axle.[1][2]

A seven-axle interlink has a steering axle and three such units, so its axle limits add up to 61,700 kg, and the 56,000 kg cap binds before they do. That total is a calculation from regulations 237 and 240, not a figure the regulations state.[1][3]

Regulation 241, the bridge formula, limits any group of axles to 2,100 kg for each metre between its first and last axle, plus 18,000 kg. Reaching 56,000 kg takes at least 18.1 m between the outer axles, again by calculation from that formula.[1][2]

Regulation 221(g) caps a combination such as an interlink at 22 m, including any drawbar or coupling. Regulation 246(c) bars carrying goods that are not safely contained or secured and "properly protected from being dislodged or spilled". An open bin of coal or sand must meet that on the road.[1][2]

Who answers for an overloaded coal truck?

The consignor and consignee carry duties of their own. Regulation 330A bars them from offering or accepting goods on a vehicle not loaded as the Act prescribes. It also bars a contract with an operator to carry goods on a vehicle that would be overloaded.[3]

A consignor must obtain from the operator "a written submission as to the payload of such vehicle and the distribution of such load" (regulation 330A(2)). Regulation 330B requires the consignor to use an accurate method of establishing the mass of the vehicle and its axles, and to keep a record of the mass of every load leaving its premises.[3]

The 2014 amendment defines a consignor as the party named in the goods declaration for more than 500,000 kg of goods a month by road. The definition also covers whoever engages the operator, controls the goods immediately before transport, or loads the vehicle at a bulk store.[3]

Regulation 330C requires the operator of a goods vehicle on a public road to carry a goods declaration. Its list requires the consignor and operator to conclude a written agreement stating the loading instructions and the parties' responsibilities, and includes a schedule of insurance. Regulation 330D bars transporting or accepting goods unless the transport is "fully insured for damages that can occur as a result of an incident".[3]

Where do coal, chrome and ore travel by road in South Africa?

Coal comes from collieries in Mpumalanga and goes by road to power stations and towards the export port of Richards Bay in KwaZulu-Natal. In 2019 the national power utility bought 118 Mt of coal for its power stations, the US Geological Survey reports. Coal exports from Richards Bay were 72 Mt that year.[10][9][12]

Road still carried around 30% of the utility's coal deliveries, a 2021 CSIR conference paper reports, because its road-to-rail targets were not met. A 2015 statement the paper cites put that haulage on about 3,200 km of Mpumalanga roads, over 30 to 40 routes.[9]

Chrome ore comes from mines in Limpopo and North West, and platinum group metals from the Bushveld Complex. Manganese and iron ore are mined in the Northern Cape.[10][11]

Sand and aggregate are industrial minerals, and the government's official guide notes that most industrial minerals are low-priced and sold in bulk, so mining them depends heavily on transport costs and the distance to markets.[11]

What does a mine require before a truck may load?

Training on the mine's hazards, before the first load. The Mine Health and Safety Act, 1996 defines an employee as "any person who is employed or working at a mine" (section 102): people working at a mine as well as those it employs.[4]

Section 10(1) requires, as far as reasonably practicable, that employees get "any information, instruction, training or supervision that is necessary to enable them to perform their work safely and without risk to health". Section 10(2) requires every employee to be properly trained in the risks and procedures of their work, and section 10(3)(a) requires that training before the employee first starts work.[4]

Section 10(3)(c) repeats it before significant changes are introduced to procedures, mining and ventilation layouts, mining methods, plant or equipment and material.[4]

What permits does a cross-border coal load need?

A cross-border permit for each truck. Section 25(1) of the Cross-Border Road Transport Act, 1998, as substituted in 2008, states: "No person may undertake cross-border road transport or, subject to section 31, cabotage, unless he or she is the holder of a permit."[6][5]

The Act's definition of cross-border road transport covers freight carried for reward or in the course of a business, to or from South Africa across its borders, on a public road. A cross-border road transport permit is issued per vehicle, for at most five years or a fixed number of journeys on specified routes. A temporary permit runs for up to 14 days.[6][5]

The Cross-Border Road Transport Agency lists goods permits among its permit types and takes applications through its online Cross-Easy system.[7]

The load also has to be proved exported. SARS's proof-of-export annexure (revision 4, effective 30 March 2026) sets when liability ends. A trader's duty liability ceases, for customs purposes, "once it is proved that the goods physically left the Common Customs Area", and for VAT purposes "once the goods left South Africa".[8]

How is coal transport by road priced?

By weight and distance. A 2021 CSIR conference paper costs the utility's road coal haulage with a 2018 estimate of about R1.18 per ton-kilometre, for a fully laden 56-ton interlink at 50% utilisation. The paper does not state whether VAT is included.[9]

The same paper notes that bulk trucks run fully laden one way and empty on the return trip, and it costs the haulage as tons times lead distance times the rate per ton-kilometre. A rate per ton or per load therefore rises with the distance between loading and offloading points and covers the empty return.[9]

A rate per ton rests on a weighbridge reading at loading or offloading. Regulation 330B already requires the consignor to establish the mass of every load and keep a record, so agree whose weighbridge ticket sets the invoice.[3]

A 2015 trade article says side-tipping interlinks are only economical when fully loaded and working every working day. Waiting at a loading point or a weighbridge cuts into that, so a request should say how loading works and how long trucks usually wait.[13]

What to put in your request

  • The commodity (coal, chrome ore, iron ore, manganese, sand or aggregate) and the tons per month and per day. The goods declaration must state the nature and quantity of the goods (regulation 330C).[3]
  • Loading and offloading points by province, the one-way distance, and whether the trucks return empty or carry a back load.[9]
  • How the trucks are loaded (front-end loader, chute or silo), which weighbridge weighs them, and who keeps the mass record.[3]
  • The truck you want: a 34 ton side tipper interlink, a side tipper semi-trailer or a PBS combination, and whether PBS approval is required on your route.[14][9]
  • The contract length, the start date and the working pattern: weekdays only, six days, or day and night.[13]
  • The rate basis you want quoted: per ton, per ton-kilometre, per load or per truck per month. Say what it must include (drivers, diesel, maintenance, tyres) and ask for the VAT basis.[9][3]
  • The mine's induction, medical and vehicle-check rules, and whether drivers must attend before the first load.[4]
  • For loads leaving South Africa: a cross-border permit for every truck, and who handles the export documents at the border.[6][8]
  • The written agreement on loading instructions and responsibilities, and the schedule of insurance for the load (regulations 330C and 330D).[3]

Questions buyers ask

What is the difference between an interlink and a superlink?

Both are a truck-tractor drawing two trailers, and the National Road Traffic Regulations name neither: regulation 221 caps such a combination at 22 m. A 2021 CSIR paper calls the standard coal interlink a 56-ton B-double with tandem axles on the trailers. A trade article describes a superlink as two trailers joined by a fifth wheel or a dolly, so ask which layout is meant.[1][9][15]

What does PBS approved mean on a coal truck?

PBS stands for performance-based standards, the Smart Truck pilot the Department of Transport has supported since 2007. In a 2021 CSIR paper, PBS coal interlinks of 74 tons gross carried about 50 tons on average, on fixed routes approved after safety, road-wear and bridge assessments. Conventional 56-ton interlinks carried about 35 tons on the same work.[9]

How many truckloads does 10,000 tons of coal take?

About 286 loads at the 35-ton average payload a 2021 CSIR paper reports for conventional 56-ton coal interlinks (10,000 divided by 35, a calculation). A PBS interlink averaging 50 tons would need about 200. Ask for the payload in writing: a consignor must get it from the operator under regulation 330A(2).[9][3]

Who must insure coal on the road?

Regulation 330D bars a consignor or consignee from transporting or accepting goods unless the transport is "fully insured for damages that can occur as a result of an incident". Regulation 330C puts a schedule of insurance in the goods declaration. Ask the haulier for its goods-in-transit cover and what it excludes.[3]

Tell us about the loads

Sources

  1. Department of Transport (Government Gazette 20963), National Road Traffic Regulations, 2000 (GN R. 225): regulations 221, 240, 241 and 246, 17 March 2000.
  2. Acts Online (consolidated text), National Road Traffic Regulations, 2000, as amended: regulations 221, 237, 240, 241 and 246, 17 March 2000, regulation 237 proviso as substituted by GN R. 846 of 2014.
  3. Department of Transport (Government Gazette 38142), Amendment of the National Road Traffic Regulations (GN R. 846): definitions of consignor and consignee, regulation 237, and new regulations 330A to 330D, 31 October 2014.
  4. President's Office (Notice 967 of 1996), Mine Health and Safety Act 29 of 1996: sections 10 and 102, 14 June 1996.
  5. Office of the President (Government Gazette 18795), Cross-Border Road Transport Act 4 of 1998: sections 1 and 25, 31 March 1998.
  6. The Presidency (Government Gazette 31366, Notice 923), Cross-Border Road Transport Amendment Act 12 of 2008: sections 2 (definitions of cross-border road transport and permit) and 4 (section 25(1)), 27 August 2008.
  7. Cross-Border Road Transport Agency, Permits, Read 18 November 2026.
  8. South African Revenue Service, SC-CF-55-A10: Acquittal and proof of export requirements, external annexure, revision 4, Effective 30 March 2026.
  9. CSIR Smart Mobility (Southern African Transport Conference), A case for high capacity coal trucks to reduce costs and emissions at Eskom, Virtual Southern African Transport Conference, 5 to 7 July 2021.
  10. U.S. Geological Survey, 2020–2021 Minerals Yearbook: South Africa (advance release), September 2025.
  11. Government Communication and Information System, Official Guide to South Africa 2017/18: Mineral Resources, 2017/18 edition.
  12. The Presidency, President Cyril Ramaphosa visits Port of Richards Bay, 24 November 2023.
  13. FOCUS on Transport and Logistics, Side-tipping trailers get the tip?, 1 September 2015.
  14. Truck & Trailer, A Look at Side Tippers from AFRIT Trailers, 21 July 2022.