Skip to content

What is a weighbridge, and how do I know its ticket can be trusted?

Weighbridge: a scale built for road vehicles, used to read a truck's mass so that its gross mass, its tare and the net load it carries can be recorded and checked against the legal limits.[2][6]

Also called Truck scale, Road vehicle scale, Mass-measuring bridge

  • A weighbridge reads a truck loaded and empty: gross mass less tare is the net load, the mass of what the truck carries, and a charge per ton is levied on that load.
  • A weighbridge used to measure for trade must pass verification under the Legal Metrology Act, and a vehicle scale must go through verification again at intervals of no more than 24 months.
  • Traffic officers can send a truck to a weighbridge and, if it is overloaded, bar it from the road until the mass complies; in a prosecution, the reading is deemed correct unless evidence shows otherwise.

Need one?34 ton side tipper truck hireHaulage

Headcore14 sources

What work do you need done?

What does a weighbridge measure?

A weighbridge reads the mass of a whole road vehicle. The Legal Metrology Regulations call it a road vehicle scale, "a vehicle scale intended for the measurement of the mass of road vehicles", and the Department of Transport's road traffic regulations define a weighbridge facility as one with a mass measuring apparatus, registered to determine the tare of a motor vehicle.[2][6]

Gross mass is the vehicle with its load, and tare is the vehicle empty. The National Road Traffic Act defines tare as the mass of the vehicle ready to travel on a road, including its spare wheel, standard equipment and permanent structure but not fuel. The net load is the gross mass less the tare, a subtraction rather than a figure a scale reads directly.[4][2]

Two kinds of weighbridge matter to a buyer of haulage. A commercial weighbridge, at a landfill, a depot or a client's site, weighs trucks before and after loading, and a charge per ton rests on its reading: Cape Town's landfill tariffs, for example, are based on the actual mass its weighbridge measures. In Johannesburg, a waste generator, building contractor or waste removal contractor depositing building waste at a disposal site must obtain a weigh bill confirming the waste's nature and weight, and keep it for 12 months.[12][13][9]

The second kind is the weighbridge used for overload control. Section 3I of the National Road Traffic Act, inserted by the National Road Traffic Amendment Act 21 of 1999, lets a traffic officer ascertain a vehicle's mass, axle mass load or axle unit mass load, require it to proceed to a mass-meter or mass-measuring device where that is needed to ascertain the mass, and, if the mass exceeds what the Act allows, prohibit its operation on a public road until the mass has been reduced or adjusted to comply. In a prosecution for a contravention of the Act, section 70 deems a mass ascertained by a mass-measuring bridge or other mass-measuring instrument to be correct in the absence of evidence to the contrary.[8][4]

What is the difference between a platform weighbridge and an axle weigher?

A platform weighbridge reads the vehicle's total mass, while an axle weigher reads loads axle by axle. The difference matters because regulation 239(1)(a) of the National Road Traffic Regulations limits the gross axle load as well as the GVM, so a total alone does not show whether one axle is within its limit.[5][12]

What is the difference between a platform weighbridge and an axle weigher?
KindWhat it readsRule that applies
Fixed vehicle scale: platform on load cells, with an indicator and printerThe vehicle's mass, printed as a ticketTested in situ, where it stands (regulation 75); verification repeated at intervals of up to 24 months (regulation 145)
Fixed or portable axle weigherAxle loads and the total, for a fleet's own load checksTo weigh a whole vehicle for a prescribed purpose, the Regulations require it to stand complete on the platform, or its axle loads to be added in an in-motion system (regulations 56 and 94); any instrument used for a prescribed purpose must pass verification (section 34(3) of the Act)
In-motion road vehicle scaleMass while the truck moves, or axle by axleApproaches of at least 10 m of concrete or a similar material that bears 20 t across any line, within 20 m over which a vehicle moves smoothly, unless the type approval certificate provides otherwise (regulation 94); verification repeated at up to 36 months (regulation 145)

Sources:[10][12][2][1]

How do I check a weighbridge's verification?

Ask the operator for the current verification certificate and look for the verification mark on the instrument. Section 34(3) of the Legal Metrology Act 9 of 2014 provides that "No measurement for a prescribed purpose may be made or effected in the Republic by means of any measuring instrument" that the Act does not permit, that is false, defective or inaccurate or, where the Act requires verification, that has not passed it. Prescribed purposes are set in relation to measurement in fields that include trade, the Regulations set the method for weighing a road vehicle for a prescribed purpose (regulation 56), and "trade" includes any contract or sale and any payment for services rendered, so weighing a load to invoice it by the ton falls within it.[1][2]

A verification officer who finds an instrument compliant must apply the verification mark, where one is prescribed, and issue a verification certificate to the person in charge of the instrument. One who finds it non-compliant must reject it by defacing the verification mark, and the instrument is then treated as having no valid verification (section 25). Using an instrument without valid verification needs the permission of the chief executive officer of the National Regulator for Compulsory Specifications (section 30(2)), and a person convicted of an offence under the Act is liable to a fine, imprisonment of up to 10 years, or both (section 39(1)).[1]

Regulation 145 of the Legal Metrology Regulations, 2017 (GN 877 of 24 August 2018) lists non-automatic weighing instruments including vehicle scales at a re-verification interval of 24 months, counted from the last verification. A verification certificate must carry the verification body's designation number, a description of the instrument, the traceability of the measurement standards used, the expiry date where a period is prescribed, and the signature of the verification officer (regulation 120). Non-automatic weighing instruments with denominated verification scale intervals must be constructed to SANS 1649, and their verification follows its Annex AA (regulation 90).[2]

Before relying on a ticket, check:[1][2]

  • that the instrument carries a verification mark that has not been defaced with a rejection mark, and that the operator holds the verification certificate issued to it as the user (section 25; regulations 66 and 120);[1][2]
  • that the last verification is within 24 months for a static vehicle scale, or within 36 months for an in-motion system (regulation 145);[2]
  • that the scale's capacity, which regulation 64 requires to be marked on it, is above the loaded truck's expected mass;[2]
  • that any repair since was followed by verification or the repairer's written guarantee (section 27(6)).[1]

What weighing records does the law ask for, and who keeps them?

The road traffic regulations set out one official weighbridge record, the mass measuring certificate. It records a motor vehicle's tare, for example when a vehicle whose tare has changed is registered or an altered vehicle is licensed again (regulations 8 and 31). It is obtained from a person in charge of a registered weighbridge facility and states the chassis number, the licence number, the tare in kilograms, the name and address of the body operating the equipment, the name and identity number of the registered weighbridge operator in whose presence the tare was determined, and the date weighed (regulation 66). GN R. 846 of 2014 left the rules for registering weighbridge facilities (regulations 66A to 66C) to come into operation on a date the Minister determines, and until a date the Minister determines, an operator of mass measuring apparatus approved by a registering authority is deemed a registered weighbridge facility for the purpose of regulation 66 (regulation 343G).[7][6][5]

The regulations define a consignor broadly, and the definition covers, among others, a person who engages an operator to transport goods by road or who loads a vehicle at a place where goods are stored in bulk. A consignor must use a method of establishing the mass of a vehicle and its axles that is accurate enough to ensure they are not overloaded, must keep a record of the mass of every load transported from its premises, and must put that record at the disposal of a traffic officer (regulation 330B).[6]

In practice, municipal tenders show what a compliant weighbridge service delivers. Elias Motsoaledi Local Municipality's 2026 request to repair and calibrate a landfill weighbridge asked for an NRCS repair permit and an NRCS verification report, and Senqu Municipality's 2025/26 tender for weighbridge maintenance disqualified bidders without SANAS accreditation for calibration and verification of weighbridges. The NRCS, which administers the Act, lists the Act and the 2018 regulations on its legislation page.[10][11][3][1]

Arrive Alive advises that vehicle weights be checked on a weighbridge before and after loading. For haulage, a request should therefore say which weighbridge's reading sets the invoice, and whether the loading end or the offloading end counts. See side tipper hire for how side tippers are hired per load, per day or per ton.[12][1]

A worked example

Take a side tipper interlink with a listed payload of 34,780 kg and a combination mass of 56,000 kg, the most regulation 237 allows. Suppose its empty ticket reads 21,220 kg and its loaded ticket reads 55,300 kg: both are assumed readings, chosen to show the method. The net load is 55,300 minus 21,220, which is 34,080 kg, or 34.08 tons, and a rate per ton is charged on that figure. The loaded mass is 700 kg under the 56,000 kg limit, and the net load is 700 kg under the listed payload. Axle loads still need their own check against regulation 240.[14][6][5]

Questions buyers ask

What is the difference between gross, tare and net on a weighbridge ticket?

Gross is the truck with its load and tare is the truck empty. Net is gross less tare, the mass of the load itself. The Act defines tare as the vehicle ready to travel on a road, without fuel, and a charge per ton, such as a landfill's disposal tariff, is levied on the load's mass.[4][13]

Can a traffic officer make a truck go to a weighbridge?

Yes. Section 3I of the National Road Traffic Act lets a traffic officer, where needed to ascertain a vehicle's mass, require it to proceed to a mass-meter or mass-measuring device, and, if the mass exceeds what the Act allows, prohibit its operation on a public road until the mass is reduced or adjusted to comply.[8]

Is a reading from a weighbridge accepted as correct?

In a prosecution for a contravention of the Act, section 70 deems a mass ascertained by a mass-measuring bridge or other mass-measuring instrument to be correct in the absence of evidence to the contrary. A driver or operator who disputes a reading therefore has to bring that evidence.[4]

Who answers for an overloaded truck: the driver or the consignor?

Both can. Regulations 239 and 240 bar any person from operating an overloaded vehicle on a public road. Regulation 330A bars a consignor or consignee, as the regulations define them, from offering or accepting goods on a vehicle not loaded as the Act prescribes, and regulation 330B obliges a consignor to establish the vehicle's mass by an accurate method and keep a record of every load.[5][6]

What work do you need done?

Sources

  1. The Presidency (Government Gazette 37661), Legal Metrology Act 9 of 2014: sections 1, 3, 25, 27, 30, 34 and 39, 19 May 2014.
  2. Department of Trade and Industry (Government Gazette 41854), Legal Metrology Regulations, 2017 (GN 877): regulations 1, 56, 64, 66, 75, 90, 94, 120 and 145 (Table 25), 24 August 2018.
  3. National Regulator for Compulsory Specifications, Legislation (lists the Legal Metrology Act and Regulation No 877 of 24 August 2018), Accessed November 2026.
  4. President's Office (Government Gazette 17603), National Road Traffic Act 93 of 1996: section 1 (definition of tare) and section 70, 22 November 1996.
  5. Department of Transport (Government Gazette 20963), National Road Traffic Regulations, 2000 (GN R. 225): regulations 8, 31, 237, 239 and 240, 17 March 2000.
  6. Department of Transport (Government Gazette 38142), Amendment of the National Road Traffic Regulations (GN R. 846): definitions of consignor, weighbridge facility and weighbridge operator; regulations 66, 66A to 66C, 237, 330A, 330B and 343G; item 78 (commencement), 31 October 2014.
  7. Department of Transport (Government Gazette 22736), Amendment of the National Road Traffic Regulations (General Notice 2116 of 2001): regulation 66 substituted, mass measuring certificate, 5 October 2001.
  8. Office of the President (Government Gazette 19971), National Road Traffic Amendment Act 21 of 1999: section 2, inserting section 3I (powers and duties of traffic officer) into the National Road Traffic Act, 28 April 1999.
  9. City of Johannesburg (Gauteng Provincial Gazette 349, Local Authority Notice 1340 of 2021), Waste Management By-laws, section 21(4), 13 October 2021.
  10. Elias Motsoaledi Local Municipality, EMLM 34/2026: Repair and calibration of Groblersdal landfill site weighbridge, 2026 (closing date 19 June 2026).
  11. Senqu Municipality, Bid No. 24/2025-2026T: Maintenance and calibration of weighbridges for three years, October 2025.
  12. Arrive Alive, Overloading and Road Safety, Accessed November 2026.
  13. City of Cape Town, Urban Waste Management, Disposal tariffs for 1 July 2026 to 30 June 2027 (Solid Waste Disposal Facility Tariff Notice), 30 June 2026.
  14. Truck & Trailer, A Look at Side Tippers from AFRIT Trailers, 21 July 2022.